Vita-mix BARBOSS MP User Manual download pdf (Page 11)

Motor Base

1. Unplug the power cord.

2. Wash outside surface with a damp, soft cloth or sponge, which has been rinsed in a

mild solution of liquid dish soap (Ivory Liquid

or equivalent) in warm water. NEVER

IMMERSE MOTOR BASE IN WATER OR OTHER LIQUID.

3. Thoroughly clean switches so that they work freely. They will become sticky from

use. Use a wet cloth or sponge* to flush and clean in the groove around the water

shielded switches. You may also lightly spray the surface around the switches with

an all-purpose cleaner such as Cinch

or 409

and work the switches back and forth

a few times to loosen any dried residue under switch.

4. Polish with a soft cloth.

*Note: Be sure to wring excess water out of cloth or sponge when cleaning around the

controls or any electrical part.

Lid

Separate the lid and plug, then wash in warm soapy water. Rinse clean under running

water and dry. Reassemble before use. (See page 5).

Container

1. To clean: Fill pitcher 1/4 full with warm (110˚F/43˚C) water and add a couple drops

of dish soap.** Return container to motor base and firmly position the two part lid.

Run machine for 30 seconds. Empty container. Repeat this step.

Note: To prolong polycarbonate container life, Vita-Mix recommends using soaps

with a low Ph balance, such as a manual pot and pan detergent. Due to the nature

of polycarbonates, automatic dishwashing is not recommended.

2. Fill pitcher 3/4 full with warm (110˚F/43˚C) water (do not add soap). Return container

to motor base and firmly position the two part lid. Run machine for 30 seconds.

Empty container.

3. If any solid residue remains, remove the blade agitator assembly (see page 8) and

wash all container parts in warm soapy water. Rinse and drain. Reassemble before

next step.

4. To sanitize: If all solid residue is gone after step 2 or after completion of step 3,

fill container 3/4 full with a sanitizing solution mix.*** Return container to motor base

and firmly position the two part lid. Run machine on HIGH for 30 seconds. Empty

container.

5. Return container to motor base and run machine empty for an additional 5 seconds.

Do not rinse after sanitizing.

*** Recommended sanitizing solution: 1-1/2 teaspoons institutional or household

bleach in 2 quarts (2 liters) water

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Vita-mix BARBOSS MP User Manual Page 11