Vita-Mix XTG012 User Manual Page 9
- Page / 28
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Tamper
Back Cover:
1. To remove the Back Cover from the Blending Station:
a. First remove the Cover Door from the unit, as described above.
b. Remove the two (2) Back Cover mounting screws located on the rear of
the machine. (Figure D)
c. From the rear of the machine, firmly push the bottom of the cover forward
(towards the control panel), keeping the bottom edge of the cover against
the motor base. DO NOT tilt or strike the cover during removal.
d. Slide forward until the side latches on the front of the cover are released
from the motor base. DO NOT strike the cover to “pop” the side latches
from their tracks. Doing so will cause damage. The cover must only
be removed by sliding it forward (towards the Control Panel).
2. To replace the Back Cover on to the Blending Station:
a. Place the Back Cover on the motor base approximately one (1) inch
forward of its normal position.
b. Slide the cover towards the back of the machine (away from the Control
Panel). Make sure the side latches slide into their tracks.
c. Push until back of cover is seated against the Motor Base.
Make sure the Back Cover is fully seated in the back and the side
latches are in their grooves before inserting and tightening the
mounting screws.
d. Replace and firmly tighten the two (2) Back Cover mounting screws.
(Figure D) DO NOT overtighten. DO NOT use the mounting screws to
pull the Back Cover into position. Doing so will cause damage.
Figure C
Figure D
Back Cover
Mounting
Screws
Back Cover
9
Hinge
Cover Door
- Blending Station 1
- IMPORTANT SAFEGUARDS 2
- SAVE THESE INSTRUCTIONS 3
- ERFORMANCE 4
- MP PRE-SET buttons 6
- PRE-SET buttons 6
- Programmed 7
- In-Counter 7
- Two-Part Lid 8
- One-Piece Lid (optional) 8
- Figure C 9
- Figure D 9
- Preparing the counter area: 10
- Electrical requirements: 10
- Blending Station dimensions: 11
- Maintenance Tips: 13
- MP using 14
- CONTINUED FROM PAGE 15 16
- Retainer Nut Wrench 17
- Item# Part 18
- Care Note 20
- Motor Base 21
- Control Panel 21
- Cover Door 21
- In-Counter Gasket 21
- Container 22
- MP On-Counter: 23
- Power Requirements: 23
- THERMAL SENSOR FAILURE 24
- MOTOR LOCKED PROGRAM 24
- TERMINATED 24
- Cooling the motor: 25
- Limited Warranty 26
- VITA-MIX 28
- CORPORATION 28
Related products and manuals for Blenders Vita-Mix XTG012
(84 pages)JVC DR-M10S manuali
Manuali dei proprietari e guide per l'utente per Lettori DVD JVC DR-M10S.
We fornisce manuali pdf JVC DR-M10S per scaricare gratuitamente in base al tipo di documento:
Comments to this Manuals