Vita-Mix XL VM0141 User Manual download pdf (Page 11)

ACCELERATOR TOOL

WARNINGS!

When processing hot liquids or mixtures:

• The two-part latching lid must be securely locked in place. DO NOT use the one piece lid or a non-

atching lid. This allows steam to escape naturally and will prevent the lid from coming off when

he machine is turned on.

• Do not start processing hot liquids on HIGH speed. Always start processing hot liquids on LOW

speed, then switch to HIGH speed while the machine is running.

• Use caution with hot liquids. Liquids may spray from under the lid plug or escaping steam may

cause scalding.

DO NOT force the accelerator tool into the container. Excessive force may cause the accelerator tool

to extend too far into the container and may cause damage to the blades.

DO NOT use the older accelerator tool that has a straight and smooth surface and no “step.” Use of

the older model may cause damage to the blades.

The accelerator tool prevents an air bubble

from forming while blending and allows for

the processing of very thick and/or difficult-to-

process frozen mixtures. While the machine is

running, use the accelerator tool to push

ingredients into the blades.

Using the Accelerator Tool:

• If thick mixtures stop circulating, you may

have trapped an air bubble. Insert the

accelerator tool through the lid and stir to

release it.

• Use it only with the lid locked in place and

lid plug removed.

• The splash disk (near the top of the accelerator tool) and lid prevent the accelerator tool

from hitting the blades.

• The container should not be more than 2/3 full when the accelerator tool is used.

• Do not use the accelerator tool for more than 30 consecutive seconds (to avoid

overheating).

• Holding the accelerator tool straight should allow extra-thick ingredients to circulate. If

not, point the accelerator tool toward the side or corner of the container.

Splash Disk

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Vita-Mix XL VM0141 User Manual Page 11